Recent content by epservices

Jon Don has a cordless scrubber that resembles the Oreck Has anyone here used it before?

He was shot in the back Even if he was carrying it would not have helped him

Yes, that’s correct

If you have had that account since 2002, then you have been doing a lot of things right and your customer will work with you Maybe there is just a build up , residue from your pre spray over the years. Since most presprays are alkaline a good acid rinse might help, along with a good flush and...

My rule of thumb is Always assume the chemical will damage the surface if it was not made for it

Also one of the things I have observed is that the motors after installation does not match the numbers specified For example the 8.4. 13.8 amp does not get the 146.6 inches of lift I do not yet have a CFM gauge so I can’t measure it After placing two in parallel the lift should be the same but...

Thank you Keep it Clean Series lowers CFM so I don’t see how it would increase in this case

If one has two separate vac boxes with two vacs in parallel, would you get the series effect if you join the exhaust of one to the intake of another? It does seem logical but was wondering what setback (cons) I would face Thanks for your response

The purpose of this forum is to inform, to seek advice , to give advice. It is to discuss different ideas . Those with a lot of experience are especially significant to this group We must be ready for our ideas to be challenged or questioned without feeling personally attacked I have gained a...

Oh boy sometimes we confuse English with. American and Ebonics!

Lol

It would if these vacs were of the same capacity or if the smaller vacs were at the end(exhaust) of the bigger vacs But if they are all independently going into the waste tank , you will be wasting energy

If your motor is not blowing air out of the exhaust or it is very weak then your motor is not doing any work

At one time I was running six motors, with two 2stage in parallel, two three stage in series, and two 8.4s in parallel I then realized that something was off I tested an saw that on the weakest motors , I was sucking in air. The bigger motors were overpowering the weaker ones and it was having...

Right now am working with 200 ft of hose with two 8.4s and a portable as a booster Am building the other box with the additional 8.4s